Dock Components

3/4" x 3-1/2" Pin used to pin dock sections together. Use with Hinge connectors

Shore Attachment for 2" ID pipe for stiff arm dock mounting

Stiff Arm Attachment - 2" ID Pipe Use this hardware to create a stiff arm that will hold your dock in place. We developed the "stiff arm " as an alternative to piling to anchor your dock in place. This system is excellent when you have a single boat dock...

Male T Connector A single "T" male has one 1/2" tab with a hole for a 3/4" bolt or pin.These can also be used for ramps or anywhere a hinge is needed. Use 1/2" carriage bolts for assembly.

Light Weight Female T Connector Single "T" female has two 1/2" tabs with a hole for 3/4" bolt or pin. Use with bolts to the side of your dock to attach fingers. These can also be used for ramps or anywhere a hinge is needed. Use 1/2" carriage bolts for...

Light Weight Outside Corner Male Outside corner male has 2-1/2" tabs with holes for a 3/4" bolt or pin. Use 3/8" carriage bolts for assembly.

Light Weight Outside Corner Female Outside corner female has 2-1/2" tabs with a hole for 3/4" bolt or pin. Use 3/8" carriage bolts for assembly.

Light Weight Outside Corner End The outside corner end is used for the ends of docks or fingers. Good for square platforms. Use 3/8" carriage bolts for assembly.

Light Weight Inside Corner End Inside corners are used with an outside corner to sandwich the wood together to create a very strong corner. The 1/2" gussett on the inside adds a lot of strength to a dock. 

Male 5''x5'' Hinge Plate

Female 5''x5'' Hinge Plate

4' Floating Wood Dock Hardware Kit, hardware only. Enough hardware for a 4' wide dock. You choose the length! CWI Floats, Frame, & Lumber not included. Inlcudes 4 Corner Brackets with bars, 4 Inside Corner Brackets, 24 Plate backings, 48 Nuts, 48...